Breast Reconstruction in Fukushima Japan
Breast Reconstruction in Fukushima section, includes general infrmation about Breast Reconstruction Procedure, Breast Reconstruction Fukushima Local News, Breast Reconstruction Fukushima Surgeon Locator and other Breast Reconstruction related material.
Breast Reconstruction Procedure
This procedure is designed for women who underwent breast amputation after breast cancer or other conditions. Newer techniques allow the surgeon to create a breast which is very similar to the natural one. The reconstruction can be done during the amputation procedure, or a few months or even a year afterwards.
There are a number of implants: the most widely used are silicon implants which have silicon surface and filling. They come in different sizes and shapes.
Becker implants are made of a thick silicon surface (35%-50%) and a solution filling. The advantage of this implant is the ability to adjust its shape to the woman's body. It can also serve as a skin stretcher. There are also implants with a thin silicon surface and a solution filling, which are less used.
The operation can be divided into 2 main categories: (a) a stretcher is inserted, then replaced with an implant; (b) the reconstruction is made from another body tissue.
The most common reconstruction is performed with a stretcher and an implant. After amputation a balloon (stretcher) is inserted under the skin and chest muscles. It has a special valve which can be filled from outside. The implant is being filled gradually with a special solution, until the skin has sufficiently stretched for inserting the implant. It takes another 3-6 months until the breast has acquired its final shape, then the nipple can be reconstructed as well.
Becker implants: sometimes during amputation the skin can be preserved. That would eliminate the need for a stretcher, and a permanent implant (Becker) can be inserted right away.
The breast can also be reconstructed with body tissue from areas with extra skin and fat, like the tummy, buttocks and back. The tissue being removed is called "a flap". Common sites to acquire the flap are the lower tummy and the lotissimus dorsi muscle from the back.
This procedure can be complicated due to implant infection, a contraction of a surface of an implant, silicon leaks and anesthetic complications.
You'll need to stay in hospital 2-7 days after the surgery, while you may feel pain and weakness for a week or two. Complete recovery may take up to 6 weeks, depending on the surgery. You may have an unusual sensation in the breast that would usually disappear over time. In most cases there could be a slight asymmetry between the breasts, however, most women report a significant improvement in their social life and self esteem.
Other Breast Reconstruction Procedures
All Breast Procedures
Breast Reconstruction fukushima (current)
fukushima Breast Lift
fukushima Breast Implants
fukushima Implant Removal
fukushima Armpit Incision
More Fukushima info...
Fukushima By plane
It is a 40-minute bus ride from Fukushima Airport to Koriyama station (¥800), from which you will then have to travel to Fukushima station by Shinkansen (¥2920, 15 minutes) or local train (¥820, 45 minutes). It may be a bit more convenient to arrive in Tokyo and take the Shinkansen from there.
-
Fukushima By bus
Six daily buses called Abukuma depart from Shinjuku in Tokyo, at a cost of ¥4800 one way; the trip takes about five hours.
Kintetsu Bus' Galaxy overnight bus service runs from Osaka and Kyoto to Fukushima. It takes approximately 12 hours from Osaka (¥12740 one way) and 10 1/2 hours from Kyoto (¥12130 one way).
-
Plastic Surgery News...
- A nano-sensor for better detection of Mad Cow Disease agentIn an advance in food safety, researchers in New York are reporting development of a nano-sized sensor that detects record low levels of the deadly prion proteins that cause Mad Cow Disease and other so-called prion diseases.
- AOptix Technologies, Inc., a leading edge developer of advanced iris recognition and ultra-high bandwidth laser communication systems, announces the hiring of Doug McNeil as Vice President of Operations. Prior to joining AOptix, Doug was VP of Engineering for Visyx, where he served since its formation in 2006.